Hioki-3273-50 Clamp on probe, DC-50MHz, 30A Needs a 3272 Power Supply
Hioki-3273-50  Clamp on probe, DC-50MHz, 30A   Needs a 3272 Power Supply

Hioki-3273-50 Clamp on probe, DC-50MHz, 30A Needs a 3272 Power Supply

Leverandør: Hioki E.E. Corporation
Varenummer: Hioki-3273-50
PDF Download: Hent brochuren her
Total er incl. moms: DKK 22.325,00
Total er excl. moms: DKK 17.860,00
Antal:
tam_new_but2
Wide-band current probe allows direct input to oscilloscope

Needs a Power Supply (3272 or 3269)

 
  • Wide band: DC to 50 MHz (-3 dB)
  • High S/N characteristic enables measuring ultra low mA-range current waveforms
  • Connects directly to oscilloscope BNC input terminal
  • Connects directly to the MEMORY HiCORDER to provide waveform monitoring
  • An optional power supply is available for use with oscilloscopes that do not provide probe power
 
Note: Connect and power up Clamp-on sensor to use in combination with the oscilloscope, or the MEMORY HiCORDER
 
 
 
Basic specifications (accuracy guaranteed for 1 year)
 
Frequency band width DC to 50 MHz (-3 dB)
Rise time =
Noise level 2.5 mA rms max. (band width limited to 20 MHz)
Continuous allowable input 30 A rms (requires derating at frequency)
Max. allowable peak input 50 A peak (non continuous)
Amplitude accuracy ±1.0 % rdg. ±1 mV f.s. (DC, 45 to 66 Hz, 0 to 30 A rms)
±2 % rdg. (DC, 45 to 66 Hz, 30 A rms to 50 A peak)
Output rate 0.1 V/A (use with a device having a 1 M-ohm input resistance or higher)
Max. rated voltage to earth 300 V CAT I (insulated wire)
Core jaw dia. Ø5 mm(0.20 in)
Power supply ±12 V ±0.5 V, 5.6 VA max.
Dimensions, mass 175 mm (6.89 in)W × 18 mm (0.71 in)H × 40 mm (1.57 in)D, 230 g (8.1 oz), Sensor cable BNC terminal: 1.5 m (4.92 ft), Power cable: 1 m (3.28 ft), Power plug: FFA.0S.304.CLAC42Z / LEMO inc.
Supplied accessories Soft case × 1